![]() ![]() ![]() Had to bight the bullet on this one and bring it to the dealers but if it helps anyone out the correct coding was as follows.Start Baud is the first baud rate that VCDS will try when connecting to a controller. On the HEX-NET or HEX-V2 the button is used to launch the VCDS Interface Config utility which is used for updating the firmware in the interface, registration, WiFi configuration and other functions.What's new : ability to flash ECU-MEM 3.0 containers introduced in newest MQB/MLB-evo control units (eg. If the (old) Hydraulics Unit is installed with a new or used ABS module these additional steps may need to be performed. Basic Setting for Brake Pressure Sensor 1 (G201) Basic Setting for Longitudinal Acceleration Sensor (G202) The video located in our MK60EC1 ABS FAQ covers the Coding and Basic Setting steps.VCP VAG CAN PRO is a dealer level diagnostic cable for vag group, an inexpensive flasher for VW, Audi, Seat, Skoda, supports CAN BUS+K-line+UDS diagnosis and programming, with latest software version V5.5.1, VAG CAN PRO supports VAG vehicles from 1990 to 2015. ![]() Lot of friendly people on the forum who can calculate the correct long code for you, but there's also modified label file on the net for lcode that also can do the job. Usually this is coded at the dealers but as your car never had EC1 pump, the system will refuse the coding.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |